⚡ Charge smarter, not harder — power your hustle wirelessly!
The Gikfun 20W Qi Charger Module Coil is a universal wireless charging component featuring a Type-C interface and built-in MCU for intelligent charge management. Supporting up to 20W fast charging with multi-level safety protections, it delivers efficient Qi-standard power transfer within an 8mm range, all in an ultrathin, lightweight design ideal for DIY and professional use.
J**G
Versatile, and work very well.
This works surprisingly well. I used this to create a phone charging pocket in my Jeep Gladiator.
M**W
Good, but not good enough
I'm making custom 3D printer chargers for family and friends. And despite making several modifications to my design, I could never get this to work when it was behind a 2mm sheet of 3D printer PLA. It would do most phones without a cover, but almost none with a cover. Just not enough power or surface. I ended up going with a dual coil charger and it has yet to NOT charge any phone.
M**E
Ford F-150 Wireless Add-On
Installed this on the underside of the front center seat back next to the cupholders on a 2022 Ford F-150 XLT where the phone-shaped indentation is. Ran a usb-c cable to the rear port, and voila! No permanent modification needed, and wireless charging added for under $20. Took about 10 minutes.Will update over time if heat dissipation becomes an issue...
M**I
It doesn't work.
It doesn't work. When I plug in the cable, it flashes red and green alternately. Bad product.
E**T
decent quality
it works with my pixel 6 pro. It has 2 leds red for standby and green for charging they are a little too bright but it works well on my 3d printed phone holder
S**K
Good
Works
K**K
Worked as described
Measurements were accurate, working as hoped. Be aware, tolerance between phone and disk is VRRY small/tight but charging fine.
F**
It works
It works. I just wish the wires between the board and the coil were longer.
Trustpilot
2 weeks ago
1 month ago