5PCS V-Groove Router Bits Set, 60° 90° 120° 150° Angle, 6mm Shank, 3D V Shape Milling Wood Cutter Knife CNC Engraving Router Bit, VG05A

I've been doing a lot of V-Carve work, and with multiple angles, you can get more effects and have some really nice products. This set of bits is one every CNC woodworker should have.

Wanted some more variety for the v-grooves in some pine tongue-and-groove paneling I'm making for a cabinet. These gave a variety of angles for the grooves where the boards meet, worked well. They also handled a little shipping issue with above-and-beyond service, so I heartily approve working with this vendor.

Work fine on my cnc router. Quality consistent with pricing. Satisfied with the product

Project wood working

Have only used two of the bits, but so far so good. They seem to cut very well, as good as some much higher-priced ones I have purchased in the past. I am very pleased up to this point.

Basically the top right bit in the first product picture comes as advertised(one that comes in the white plastic container) and made in a decent quality. However the other 4 bits vary in condition. I added an overall picture of all 5 bits and two pictures featuring the worst of the issues. The seller has tried to send me another set in response to my messages. There has been a slight improvement with the second set but not what I would call decent. Again, the bit that comes in the white box is the standout piece that looks good. I feel like that the bit that came in the white box were made in a different factory as it has a completely different quality to the other 4 bits. I will say that the seller doesn't give you a hassle when there is an issue and takes responsibility for bad bits. This is the only reason why my review is a 3 star instead of a 2 star. I hope they can improve these router bits for the next buyers as they have an interesting product here.

I only used the big 32mm 60 degree bit and it the tip broke off on the first pass in soft wood…. Before it broke it was jumping and grabbing all around. I’ve never had a router bit break… poor quality steel and bot sharp.

For the price, skip this and buy one good bit that you'll actually use. Half of my bits arrived unusable out of the box, one of which has a 1/8" gap between the blades making plunging impossible and incredibly dangerous. When I finally tried one of the bits that "looked" okay, it was so dull that even at incredibly conservative settings in hard maple it tore the wood more than cut it and left terribly jagged lines worse than the little 20 degree v bit that comes with the machine (my machine is a 4030 proverxl). This is a complete waste of money and I'll definitely be returning them.